Stock

1.4541 (X6CrNiTi18-10) Material Data Sheet

Back to category page

1.4541 (X6CrNiTi18-10) directly from stock & cut to your required dimensions

International identifiers
Scopes

The material 1.4541 is comparable to the steel grade 1.4878

1.4541 is used when resistance to intergranular corrosion is desired after welding. However, due to the titanium stabilization, the material tends to form lines and is thus affected by knife-edge corrosion.

This material is often replaced by steels with low carbon contents (less than 0.03%) for example the 1.4307, as they have the same corrosion resistance does not cause the above-mentioned disadvantages caused by titanium.

The chemical composition and properties are comparable with the material 1.4301.

Good corrosion resistance in natural environmental media (waters of rural and industrial atmosphere). The prerequisite is that chlorine and salt concentrations as well as concentration of nitric or organic acids are low.

The 1.4541 is also known under the classification AISI 321.


Aplication Areas

Automotive industry, construction industry, chemical industry, food industry, aerospace, mechanical engineering.

Characteristics

Solution annealed, quenched

Weldability:       excellent

Machinability:   4 (1 = very bad - 10 = good)

Polishability:     no

Corrosion class:   3 (0 = weak - 5 = good)

 

Calculate the weight of the required material quickly »

Chemical composition
1.4541
X6CrNiTi18-10
CSiMnPSCrMoNiV
min.bisbisbisbisbis17,0 9,0   
max.0,081,02,00,0450,0319,0 12,0   
1.4541
X6CrNiTi18-10
AlCuNNbTiSonstiges
min.            5xC   
max.            0,7   
In stock

flat, forged, solution annealed, tempered and aged
round, forged, solution annealed and tempered

StahlblockRundstahl
Advantages of saw cut

The processing with the saw is a mechanical processing of the material, which results in a significantly lower unintended deformation and increased hardness for the existing structure, such as the thermal cutting.

Thus, the machined workpiece has a homogeneous structure even at the edge, which does not change in the continuation of the material.
This circumstance allows immediate finishing of the workpiece with milling or drilling . So it is not necessary to anneal the material or make a similar operation beforehand.

Do you have any questions?

We are happy to answer your questions and make you an offer for these and other materials. Contact us now for more information.

Alexandra Herbig

Your contact person Alexandra Herbig+49 (0) 35263-665-28

contact now

Notice: Specifications contained in following data sheet are provided as a description, liability is excluded!

 


More stainless steel

1.4021 1.4057 1.4104 1.4112
1.4122 1.4313 1.4410 1.4418
1.4462 1.4542 17-4PH

All stainless steel cuts