Stock

1.4410 (X2CrNiMoN25-7-4) Material Data Sheet

Back to category page

1.4410 (ASTM A182 F53 ) directly from stock & cut to your required dimensions!

International identifiers
ASTM A182 F53, A276, S32750, SS2328, SAF 2507 , SS2328 
Scopes

1.4410 is a corrosion resistant, austenitic-ferritic super-duplex steel. An austenite/ferrite structure and small grain size provide the material with its hardness, strength, and toughness. The super-duplex steel 1.4410, also known as F53, is used for components where conventional austenite and corrosion-resistant duplex steels (1.4462) fail to fulfil the corrosion requirements. The steel is characterised by excellent resistance in media containing chlorine and has been approved in NACE MR 0175 for sour gas applications and granted ASME approval for pressure vessels.

For comparison: Duplex Steel or Super Duplex

Areas of application:
Oil and gas industry, onshore/offshore industry, textile, paper and pulp industry, tank construction, chemical tanker construction and mechanical engineering.
 

Characteristics

Solution annealed max. 270 HB

Weldability:         good

Machinability:     3 (1 = very bad - 10 = good)

(Machining properties are roughly comparable with those of 1.4462)

Corrosion class:   4 (0 = weak - 5 = good)

 

Properties according toDIN EN 10088-3:

Tensile strenght Rm730 – 930 MPA
Minimum yield strength Rp0,2530 MPa bei RT
 380 MPa bei 250°C
Elongation A (along)25 %
Notch impact energy (along)100 J

 

Calculate the weight of the required material quickly »

Chemical composition
1.4410
X2CrNiMoN25-7-4
CSiMnPSCrMoNiV
min.     243,06,0   
max.0,0300,81,20,0350,015264,58,0   
1.4410
X2CrNiMoN25-7-4
AlCuNNbTiSonstiges
min.      0,24         
max.   0,50,35         
In stock

flat, forged, solution annealed, pre-machined

Stahlblock
Advantages of saw cut

The processing with the saw is a mechanical processing of the material, which results in a significantly lower unintended deformation and increased hardness for the existing structure, such as the thermal cutting.

Thus, the machined workpiece has a homogeneous structure even at the edge, which does not change in the continuation of the material.

This circumstance allows immediate finishing of the workpiece with milling or drilling . So it is not necessary to anneal the material or make a similar operation beforehand.

Do you have any questions?

We are happy to answer your questions and make you an offer for these and other materials. Contact us now for more information.

Antje Schroeder

Your contact person Antje Schroeder+49 (0) 35263-665-13+49 (0) 35263-665-35

contact now

Notice: Specifications contained in following data sheet are provided as a description, liability is excluded!

 


More stainless steel

1.4057 1.4104 1.4313 1.4418
1.4462 1.4542 17-4PH

All stainless steel cuts